How to change filter sand? | Piscine.fm: buying guide pools, pool enclosures and accessories
How to change filter sand?
To ensure a good swim, it is natural to properly maintain the pool of your dreams. Perform proper maintenance means to automatically effective filtration. When it comes to a sand filter which is very common in the majority of pool owners, it is recommended to follow puricom europe good 5 steps to a good water filtration pool are:
- Consider puricom europe the quantities of sand and gravel needed. In fact, before puricom europe you start filtering operation, make sure the necessary amount of sand and gravel which is relative to the size of the filter. You will find instructions that will give you the necessary explanations. The proportions of filter media are 1/3 gravel and 2/3 sand.
- When you begin, close all valves and let the filter puricom europe drain its water through the drain plug at the bottom of the filter. In the case where the filter is located on the valve top, unscrew the connections and remove the valve. If the valve side is on the coast, just remove the cover.
- The cleaning of the filter elements is done by a vacuum air / water removes sand and gravel, but not exceeding half of the vacuum to avoid exceeding the engine. Make disassemble and clean the strainers with an acid solution for better chemical disinfection of the filter.
Then screw back the drain plug and seal the central pipe. Pour water into the filter up to about 10 cm above the screens that should be well covered with gravel (up to 5 cm above the screens) and add sand to the level indicated, the equivalent puricom europe of 2/3 of the total capacity of the filter.
Finally, and before starting the filtration, do not forget to check the seals of the 6-way valve or cover according to the assembly puricom europe of your filter. At this point, you can stimulate the process puricom europe of filtration.
2010 - 2011 all rights reserved RCS Versailles B 523 495 000 Contact us
How to change filter sand?
To ensure a good swim, it is natural to properly maintain the pool of your dreams. Perform proper maintenance means to automatically effective filtration. When it comes to a sand filter which is very common in the majority of pool owners, it is recommended to follow puricom europe good 5 steps to a good water filtration pool are:
- Consider puricom europe the quantities of sand and gravel needed. In fact, before puricom europe you start filtering operation, make sure the necessary amount of sand and gravel which is relative to the size of the filter. You will find instructions that will give you the necessary explanations. The proportions of filter media are 1/3 gravel and 2/3 sand.
- When you begin, close all valves and let the filter puricom europe drain its water through the drain plug at the bottom of the filter. In the case where the filter is located on the valve top, unscrew the connections and remove the valve. If the valve side is on the coast, just remove the cover.
- The cleaning of the filter elements is done by a vacuum air / water removes sand and gravel, but not exceeding half of the vacuum to avoid exceeding the engine. Make disassemble and clean the strainers with an acid solution for better chemical disinfection of the filter.
Then screw back the drain plug and seal the central pipe. Pour water into the filter up to about 10 cm above the screens that should be well covered with gravel (up to 5 cm above the screens) and add sand to the level indicated, the equivalent puricom europe of 2/3 of the total capacity of the filter.
Finally, and before starting the filtration, do not forget to check the seals of the 6-way valve or cover according to the assembly puricom europe of your filter. At this point, you can stimulate the process puricom europe of filtration.
2010 - 2011 all rights reserved RCS Versailles B 523 495 000 Contact us
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.